link mail

  • small dimensions

  • cover IP65

  • easy application

  • reasonable price

DZ - digital visual display unit

Basic technical information of pressure transmitter

Display± 3,5 digit /±1999
Errormax. 1% (0,5%)
Temperature range-20 ÷ +55°C (non condensing)
Input4 ÷ 20mA two-wire
0 ÷ 20mA three-wire
0 ÷ 10V three-wire
Supply current – input G,H5 ÷ 36V dc
Supply current – input G,Htyp. <4mA
Voltage depletion – input F8V
Fuse input F,G63 mA
Operating positionarbitrary
Protectionmin. IP 65
Weightcca 100g

Instructions for use

  • Visual display unit, which is connected via the connector, requires no special procedures for its assembly.
  • In case of connecting display unit by cable, is first step, removing the lid of the enclosure. Then dismount upper printed circuit board with display, holds by two screws. Pull it out of box very carefully. Screw down wires in to the terminal block of bottom printed circuit board. Take care to wires which can block mounting of upper printed circuit board. Then screw tight the nut grommets. During instalation of upper printed circuit board pay attention to correct insertion of contact pins to connector, which connects upper and bottom board! Finaly screw display board by two screws and carefully fasten enclosure screws.



Dimensions of pressure transmitter

Dimensions of pressure transmitter
copyright 2010 | Sitemap | Portfolio |